IT Standard Equipment Set up
Equipment:
Surface Laptop
Headset
Mouse
Microsoft Surface Docking station
Monitor
Surface Laptop:
Microsoft Surface Laptop 2
1 x full-size USB 3.0
3.5 mm headphone jack
Mini DisplayPort
1 x Surface Connect port
Microsoft Surface Laptop 3
1 x USB-C™
1 x USB-A
3.5 mm headphone jack
1 x Surface Connect port
Microsoft Docking Station
2x Mini display ports
1x Gigabit Ethernet port
4 USB 3.0 ports
1x audio out port
Mouse: Comes with a USB connector (inside, where the batteries are) that must be connected in order to work.
Headset: Jabra headset. It comes with a connector to a USB, but if unplug from the connector, it can be plugged in as a headphone jack
Epitec Monitor Setup:
Open opening the box you should have these multiple components: the monitor screen, monitor arm, the docking station, the power cable and the mini display cable. Depending on the monitor that you have, the mini display cable end could vary (the most common cable is the HDMI to mini display)..
The monitor screen will easily click onto the monitor arm. Once it is put together, you can plug the HDMI (or other) cable and power cord into the back of the monitor.
Then, you can plug the power cord into the outlet and the mini display cable into the docking station.
Once you connect all the equipment to the power outlet and the docking station, you can connect your PC to the docking station using the charging port, and you are good to go!
Please note that it is normal for the laptop screen to flicker black a few times upon startup/plugging into the docking station. This is just all of the equipment trying to get acquainted with one another!
To configure the additional screen on your laptop, please refer to Setup Screen/Monitor - Knowledge Base - Epitec Wiki (atlassian.net)